1. Features vitrified after the beads are glass beads insulation mortar lightweight aggregate as the main raw material, adding inorganic cementitious materials and a variety of additives, by pre-mixed dry mortar mix made of inorganic insulation. Product features are as follows: 1) small thermal conductivity, good insulation effect 2) water resistance, shrinkage rate is small 3) hydrostatic shear and strong 4) thixotropic, good workability 5) good resistance to freeze-thaw performance, stable performance Durable 6) good wind pressure resistance 7) Stable quality: Industrial giant glass beads of insulation mortar use of industrial production, to optimize the ratio of raw materials, strictly controlled to ensure the consistency of the material from the fundamental stability and reliability easy to control the thickness of the construction, the construction of high adaptability and efficiency: early strength quick-drying, the process is simple, greatly shorten the construction period. Low 8) Cost: The system construction in dry form directly on the base, leveling layer and insulation combined, greatly reducing the construction cost. 9) overall good: fully bonded insulation system with grass, no cavity to form a continuous whole, to ensure that the insulation layer is firmly secure, on-site construction can freely shape, especially for use in ceiling shaped parts and inverted faces. 10) Fire resistance: material flammability grade A, can withstand 1000 degrees Celsius temperature, make up the existing organic flammable insulation material defects poison gas temperature is within the insulation stairwell, fire exits and other preferred products. 11) Green: new inorganic materials, non-toxic, no radiation, is a real green building materials, while creating value, clean up the environment, with excellent social benefits. 12) live longer: for a good fire, sound-absorbing, breathable, water-resistant properties of ice melt, which can reach 70 years of weathering, ensuring primary wall insulation system and have the same life. 2. Scope 1, for interior and exterior wall insulation and external wall insulation and a variety of composite insulation brick structure, frame, exterior structure of shear wall structure. 2, roof, walls, basement, garage, stairs, corridors, fire exits. 3. Product Performance (List) Dry apparent density (kg / m3) ≤300 thermal conductivity (W / m? K) ≤0.065 Wet apparent density (kg / m3) ≤680 linear shrinkage (%) ≤0.3 Compression strength (MPa) ≥0.30 tensile strength (MPa) ≥0.15 bond strength (MPa) ≥0.1 softening coefficient ≥0.60 ≥1.0 setting time initial set final setting ≤2.0 Regenerative coefficient (w / ㎡.k) ≥0.9 4. Construction Technology 1. Wall insulation will need to be cleaned. 2. The glass beads of dry mortar adding the right amount of water, stir. 3. Stir well with insulation slurry distribution, not less than one per square meter according to the design requirements of insulation thickness. 4. Apply 2-3 times the insulation layer is completed. The first pass compaction requirements try to make it a strong bond with the wall, and try to make thick. The Nature Conservancy noise to be dry 3-4 hours after applying 2-3 times, and leveling the calender. 5. Drip split seam should apply during the second pass directly embedded within the insulation. 6. After the basic insulation dry cloth or a paste made of steel wire mesh (interior and exterior insulation may not mesh). 5. Note 1) Construction of the temperature should not fall below 5 ℃, the insulation layer to dry for about 2d after curing (by not moving with the palm appropriate), and then the construction of the protective surface layer. 2) mixing good insulation slurry must run in 1h, prohibit the use of outdated ash. 6. Storage Storage 8 months, rain, moisture, sun-ventilated dry conditions;